SIKA-MultiSeal Grey 10m * 10m-3732

SIKA-MultiSeal Grey 10m * 10m-3732

The substrate must be stable, clean, dry and free from All surface pollutants. Preparation Substrate All loose particles, surface processors, concrete skin, Paints, rust and other materials with low adhesion should be removed with Appropriate manual preparation technique by hand or by mechanical means. Metal, plastic substrates etc must be thoroughly cleaned with solvent (e.g. Sika® Activator-205). On porous substrates (concrete, plasters, etc.) adhesion can be Improved with an asphalt primer (e.g. Igol A). Allow the primer to dry for At least 1 hour. Application conditions/ Restrictions Temperature Substrate + 5 °C minimum/+ 40 °C Maximum At temperatures below + 100 C the film and substrate must be Before and during application. Use equipment Hot air. Temperature Environment + 5 °C minimum/+ 40 °C Maximum At temperatures below + 100 C the film and substrate must be Before and during application. Use equipment Hot air. Substrate humidity the substrate must be dry. 3 3/3 Sika® MultiSeal® . Application Guidelines Method of application/ Tools Cut the tape to the necessary length, remove the membrane and press the tape Firmly on the substrate with a suitable pressure roller. All joint joints must overlap by at least 50 mm. Note: Adhesion to the substrate can be increased by heating the Tape with a hot air dryer during application. Application Notes/ Restrictions It is not suitable for sealing when there is water pressure. For Applications Water pressure Sealing, please contact your local Technical service of Sika. It is not suitable for applications over the head and at high Temperatures (> + 250 C). Due to the bituminous content of the film, dyes, plastics and Natural stones can change color. On porous substrates, it is possible to penetrate water under the Sika® MultiSeal® .