VITEX - Acrylan Elastic / Elastomeric Sealant White Paint 3lt - 11705

VITEX - Acrylan Elastic / Elastomeric Sealant White Paint 3lt - 11705

Elastomeric waterproofing paint of external vertical surfaces based on special 100% acrylic UV-interlocking resins. It is applied to new and old surfaces of plaster, concrete, bricks, etc. It offers flawless final surface, excellent resistance to adverse atmospheric conditions, air pollution and the coastal environment, without requiring repainting with acrylic paint. It fully covers small cracks of the surface and monitors contractions and expansions, remaining elastic at temperatures from –25οC to +110οC, while giving it waterproofing properties. The final surface and shades remain unchanged for years, without signs and traces of rain (snake trails).

• 4 in 1: Insulates, paints, closes microcracks, breathes
• With 100% acrylic UV-interlocking resins
• RESISTANCE to extreme weather conditions and HD shades
• Certified cold material

SPECIAL FEATURES
Certified by the University of Athens, Department of Physics, for its properties as a cold material, with:
Initial all-spectral reflectivity to solar radiation SR = 0.86 (300-2500nm) (ASTM E 903-96 and ASTM G 159-98)
Infrared emission factor ε = 0.88 (ASTM E 408 –71 –2002)
Solar reflectance index SRI = 108 (ASTM E 1980-01)

NUANCES
Available in white and an unlimited number of shades through Vitexs Colorfull Tinting System.

PREPARATORY WORK

The surfaces must be clean, dry and smooth, free of dust, oil or any loose materials.For puttying holes and spatulating any cracks, Acrylic Building Putty is used.Old water-colored surfaces (with lime or glue) are primed with Durovit or Acrylan Unco Eco or Vitosin.New surfaces of plaster, concrete, bricks, etc., as well as spatulated surfaces are primed with Durovit or Acrylan Unco Eco.

APPLICATION

The product is thoroughly stirred before use. It is applied in two layers with a roller, brush or airless gun and diluted up to 15% with water. It should not be applied at temperatures below 5oC, higher than 35oC and/or relative humidity above 70% or if there is a risk of rain or frost in the next forty-eight hours.The product is dry to the touch in 2-3 hours and repainted after 6-8 hours. These times vary depending on weather conditions (relative humidity and temperature).The tools are cleaned immediately after use with water and if necessary with soap or detergent.